Data Sheet SG-600
Digitally controlled voltage scan generator	Two independently operating voltage scan channels, galvanically isolated from the line connector
Operation modes of each channel:	single scan (INITIAL-A) up/down (INITIAL-A-B) continuous scan (INITIAL-A-B-A-B-A-B-...)
Control functions of each channel:	Set INITIAL voltage RUN voltage scan REVERSE voltage scan HOLD voltage scan at actual voltage
Voltage scan range (i.e. A and B voltage setpoint range) :	± 5 V
INITIAL voltage setpoint range:	± 5 V
Voltage scan rates:	0.2 mV/s 0.5 mV/s 1 mV/s 2 mV/s 5 mV/s 10 mV/s 20 mV/s 50 mV/s 100 mV/s 200 mV/s 500 mV/s 1 V/s 2 V/s 5 V/s 10 V/s 20 V/s 50 V/s 100 V/s 200 V/s 500 V/s 1000 V/s
Voltage scan rate inaccuracy:	< ± 5 x 10-5
Opto-isolated trigger inputs for RUN and INITIAL of each channel	rising edge of a +5 V - pulse, 8 mA
Six 4½ - digit red LED displays for simultaneous display of A voltage, B voltage, either INITIAL voltage or actual output voltage of each channel	Display resolution: 1 mV
The trigger capability of both scan channels allows to use SG-600 as a generator for arbitrary voltage pulses and double step voltage pulse sequences.

This page last updated on Apr 2, 2004